Stop Plate

This section defines and provides resolutions for common hardware issues for the Stop Plate on which the Gantry is squared against before Aligning the Head.

Stop Plate Definition: Square the Gantry against the Stop Plate before Aligning the Head.
This establishes the Gantry and Head starting position, ensuring consistent alignment and precise Horizontal cut placement on CMC Boards with this feature.

Usage:

Square the Gantry against the Stop Plate before Aligning the Head.
This establishes the Gantry and Head starting position, ensuring consistent alignment and precise Horizontal cut placement on CMC Boards with this feature.

Stop Plate Installation

Stop Plate Connections and Controls:

The Stop Plate is attached to the far left of the bottom Board Rail.
Use the Stop Plate to square the Gantry against before Aligning the Head to establish the Gantry and Head starting position, ensuring consistent alignment and precise Horizontal cut placement on CMC Boards with this feature.

Troubleshooting:

Make sure that the Stop Plate was reinstalled onto the Board Rail to the left side of the Gantry.