This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw


Vertical Adjustment (Tool Specific): FrameShop Configurations Screen

Vertical Adjustment

Vertical Adjustment

Use the Vertical Adjustment if the non-blade tool (Deboss, Pen or Vinyl) is being applied to the wrong place vertically.

Adjust the Vertical Adjustment if the Tool Object is Applied in the Wrong Place Vertically

Select the Tool and Type

Select the Tool and Type

Make sure to select the desired tool from the Cartridge Type Tab and then the tool type you want to edit from the Current Bevel Type dropdown control, if applicable, before making adjustments.

Select the Desired Tool Tab and Current Bevel Type if Applicable

Tool Line Too Far Down

Tool Line Too Far Down

The tool line is applied too far down.

Increase the Vertical Adjustment to move the tool line up.

The object will now be applied in the correct place.

When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Tool Line Too Far Up

Tool Line Too Far Up

The tool line is applied too far up.

Decrease the Vertical Adjustment to move the tool line down.

The object will now be applied in the correct place.

When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Opening Cuts in the Wrong Place Vertically when not cutting the Outside

Opening Cuts in the Wrong Place Vertically when not cutting the Outside

Make sure that the opening is being cut in the correct place. If the opening is cutting in the wrong place Vertically when you are not cutting the outside of the mat, see Vertical Home.