This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw


Overshoot (Tool Specific): FrameShop Configurations Screen

Overshoot

Overshoot

Overshoot is how far past each segment to apply the current non-blade tool (Deboss, Pen or Vinyl).

This is similar to an Overcut, and is used to make the corners connect better.

The Overshoot is displayed on the Configuration Map as a blue arrow. 

Adjust the Overshoot to Adjust How Far the Tool Object Passes the Corners

Tool Line Too Long

Tool Line Too Long

If the Overshoot retracts the tool too late, it makes the Overshoot too long.

The Overshoot Tool Lines are Too Long

Decrease the Overshoot.

The corners will now meet up properly.

When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Tool Line too Short

Tool Line too Short

If the Overshoot retracts the tool too soon, it makes the Overshoot too short.

Increase the Overshoot. 

The corners will now meet up properly.

When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved.