/
Editing the Configurations: FrameShop Configurations Screen

This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw


Editing the Configurations: FrameShop Configurations Screen

Editing the Configurations

Editing the Configurations

Use the Configurations Screen to make adjustments to either how the CMC cuts or how it applies the non-bladed cartridges.

Below is a list of support documentation for the Configurations Screen of the FrameShop software. Select which approach you want to take in identifying the cutting issue and resolving it by editing the Configurations.

Select the Cartridge Type to Edit

Select this topic for information on the Cartridge Type Tabs.

Select the Cartridge Type Tab to Edit

Bevel Type/Cartridge Type

Select this topic for information on the Bevel Types/Cartridge Types available from the Bevel Type dropdown control.

Select the Desired Bevel Type From the Bevel Type Dropdown Control

Configurations Screen Section

Select this topic for information on the Configurations Section you want to edit.

Select the Desired Section of the Configurations to Work On

Configuration Field

Select this topic for information on the specific Configuration Fields.

Select the Desired Configuration Field You Want to Edit

Troubleshooting

Select this topic for information on the Troubleshooting utility to quickly edit the configurations for a single object.

Select the Troubleshooting Utility to Make Quick Configuration Changes

Quick Calibration

Select this topic to see information about the Quick Calibration which walks through making sure the opening is the right size, cut in the right place, as well as adjust the backups and overcuts and correct for swoops and flares.

Create a Small Simple Opening to Use for Calibrating the CMC

Related content