Width Adjustment (V-Groove): FrameShop Configurations Screen

V-Groove Width Adjustment

V-Groove Width Adjustment
Adjust the Width Adjustment if the V-Groove is cutting too thin or too wide.	The Width Adjustment Field Controls the Width of the V-Groove Line

Current Bevel Type

Current Bevel Type
Make sure to select the desired Cartridge Tab and then select V-Groove from the Current Bevel Type dropdown control before making adjustments.	Select the V-Groove Bevel Type From the Bevel Type Dropdown Control

V-Groove Width is too Thin

V-Groove Width is too Thin
The V-Groove is cutting too thin.
Increase the Width Adjustment.
The object will now cut correctly.
When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved.

V-Groove Width is too Wide

V-Groove Width is too Wide
The V-Groove is cutting too wide.
Decrease the Width Adjustment.
The object will now cut correctly.
When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Opening Adjustment: V-Groove

Opening Adjustment: V-Groove
To adjust the opening size of the V-Groove, see Opening Adjustment: V-Groove.

Width of an Open V-Groove

Width of an Open V-Groove
To adjust the width of an Open V-Groove, see VG-Width in the V-Groove Properties.
A VG-Width value larger than zero is an Open V-Groove.

FrameShop 4x