Pen Configurations: FrameShop Configurations Screen

The Pen Cartridge draws onto the matboard with the selected pen.

Select this topic to see information on editing the configurations for the Pen Cartridge on the Pen Tab.

Select the specific Pen to edit from the Cartridge dropdown control. Note that each pen has its own set of configurations.

Below is a list of support documentation for editing the configurations of the Pen Cartridge on the Pen Tab.

This is viewed from the front of the mat. Select this topic to see information on editing the Pen Horizontal Adjustment.

This is viewed from the front of the mat. Select this topic to see information on editing the Pen Vertical Adjustment.

This is viewed from the front of the mat. Select this topic to see information on editing the Pen Opening Adjustment.

Select this topic to see information on editing the Pen Depth Setting.

Select this topic to see information on editing the Pen Corner Pause. 

This is viewed from the front of the mat. Select this topic to see information on editing the Pen Overshoot.

This is viewed from the front of the mat. Select this topic to see information on editing the Pen Overshoot.

Select this topic to see information on editing the Plunge between segments.

Select this topic to see information on configuring different pens with the Install Pen calibration utility.

Select this topic to see information on the Troubleshooting utility to make quick edits to the Configurations for a single object on the Cutting Preview.

Set up the Pen Defaults in the Admin Editor section of the software.