This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw


Corner Pause (ms) (Tool Specific): FrameShop Configurations Screen

Corner Pause

Corner Pause

The Corner Pause is the amount of time, in milliseconds, to pause the application of the non-blade tools (Deboss, Pen or Vinyl tool) in the corners to avoid tearing the mat.

Corner Pause Controls the Time of Pause in the Corners to Avoid Tearing the Mat

Tool is Tearing the Mat Surface

Tool is Tearing the Mat Surface

The tool is causing tearing in the corners of the segments as it is being applied. 

Check the Blade Depth to make sure it is not too deep.

Increase the Corner Pause.

Adjust the Corner Pause until you get satisfactory results.

Increase the Corner Pause if the Mat is Tearing in the Corners