This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw


Arc Design Details: FrameShop Trace Editor

Arc Design Details

Arc Design Details

Click on an Arc to see the specific details about it.

Note: If you bring in the design from Designer, Offset the Arc and select the offset, or Convert Arcs to Splines, then clicking on the "Arc" will display Curve/Spline information. This section is only for Arcs created within Trace.

The Design Details section displays information about the selected arc.

Design Arc Details

Design Arc Details

Start X and Start Y 

Displays the Start X/Y Coordinates of the arc's start point when drawn. If you clicked on the upper left and drew by dragging to the lower right, that would make the start point in the upper left corner. 

Mid X and Mid Y 

Displays the Mid point X and Y Coordinates.

End X and End Y 

Displays the End Point X and Y Coordinates.

Radius 

Displays the Radius of the selected arc.

Length 

Displays the Length of the Arc in the current dimensions.

Bevel Type 

Displays the Bevel Type if the current object is traced.

Layer 

Displays the Layer this object is assigned to if it is traced.Â