This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw


Offset Tool: FrameShop Trace Editor

Offset Tool

Offset Tool

The Offset button creates a displacement copy of the selected object a parallel distance away. The distance is specified in the Offset reveal field.

Offsetting an Object

Offsetting an Object

Click on the desired object.

Select the desired direction (*see Rules below) to create the new offset from the Offset dropdown control. 

For a closed object: 

  • A positive value offsets to the inside.

  • A negative value offsets to the outside.

Enter the desired offset amount in the Offset reveal field.

Click the Offset button.

The object will be offset in the direction and by the amount specified.

*RULES:

*RULES:

Enclosed Objects:

  • Positive value offsets to the inside.

  • Negative value offsets to the outside.

  • Arcs and Curves Greater than 180 Degrees use the same rules as closed objects. 

  • For lines, imagine a line's start point to be the center of a circle. The plus offsets clockwise and minus offsets counterclockwise.

  • If it doesn’t offset in the expected direction, click Undo and change the value offset direction.