This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw


Curve Design Details: FrameShop Trace Editor

Curve Design Details

Curve Design Details

Click on a Curve to see the specific details about it.

Note: If you bring in the design from Designer, Offset the Arc and select the offset, or Convert Arcs to Splines, then clicking on the "Arc" will display Curve/Spline information. 

The Curve Design Details section displays information about the selected curve.

Design Curve Details

Design Curve Details

Start X and Y 

Displays the Start X/Y Coordinates of the curve’s start point when drawn. If you clicked on the upper left and drew by dragging to the lower right, that would make the start point in the upper left corner. 

Mid X1 and Y1 

Displays the first Mid Point X1 and Y1 Coordinates.

Mid X2 and Y2 

Displays the second Mid Point X2 and Y2 Coordinates.

End X and Y 

Displays the End Points X and Y Coordinates.

Bevel Type 

Displays the Bevel Type if the current object is traced.

Layer 

Displays the Layer this object is assigned to if the object is traced.