Overshoot (Tool Specific): FrameShop Configurations Screen
Overshoot | |
---|---|
Overshoot is how far past each segment to apply the current non-blade tool (Deboss, Pen or Vinyl). This is similar to an Overcut, and is used to make the corners connect better. The Overshoot is displayed on the Configuration Map as a blue arrow. | Adjust the Overshoot to Adjust How Far the Tool Object Passes the Corners |
Tool Line Too Long | |
---|---|
If the Overshoot retracts the tool too late, it makes the Overshoot too long. | The Overshoot Tool Lines are Too Long |
Decrease the Overshoot. | |
The corners will now meet up properly. | |
When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. |
Tool Line too Short | |
---|---|
If the Overshoot retracts the tool too soon, it makes the Overshoot too short. | |
Increase the Overshoot. | |
The corners will now meet up properly. | |
When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. |