This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw


Inside Rotation (V-Groove): FrameShop Configurations Screen

V-Groove Inside Rotation

V-Groove Inside Rotation

Adjust the Inside Rotation if you are getting Swoops or Flares in the corners of a non-oval V-Groove.

The Inside Rotation controls how much the foot block will rotate before cutting the outside of the V-Groove.

The inside cuts of the V-Groove are Interior cuts, and cut into the V-Groove fallout and not the matboard. They cut on the first pass of the V-Groove, and are cut in a clockwise direction.

If you have too little Inside Rotation on a non-oval V-Groove you will get a Swoop, too much rotation and you will get a Flare. 

Inside Rotation Adjusts for Swoops or Flares in the Corners on the Inside Cut of a Non-Oval V-Groove

V-Groove Inside has a Swoop

V-Groove Inside has a Swoop

The beginning of the inside cut of the V-Groove Swoops toward the non-oval V-Groove opening.

Inside V-Groove Cut Swoops on the Non-Oval V-Groove

Increase the Inside Rotation. 

The object will now cut correctly.

When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved.

V-Groove Inside has a Flare

V-Groove Inside has a Flare

The beginning of the inside cut of the V-Groove Flares away from the non-oval V-Groove opening. 

Decrease the Inside Rotation. 

The object will now cut correctly.

When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved.

V-Groove Outside Rotation

V-Groove Outside Rotation

Select this topic to see information on the Outside Rotation (V-Groove) to adjust the rotation for the outside cut of the non-oval V-Groove.