The User Configs is where the user can adjust the individual configuration settings for the Cartridge Tab selected. 

Cartridge Type Examples 

Select this topic to see information and examples of the different Cartridges that are available.

Bevel Type Examples 

Select this topic to see information and examples of the different Bevel Types available.

Current Bevel Type 

Select this topic to see information about the different bevel types available from the Current Bevel Type dropdown control. The selections available are dependent upon the Cartridge selected.

Backups and Overcuts 

Select this topic to see information about the Backups and Overcuts which adjust specifically where the blade plunges in and retracts from the matboard when cutting objects.

V-Groove Backup and Overcuts

Select this topic to see information about the V-Groove Backup and Overcuts which adjust specifically where the blade plunges in and retracts from the matboard when cutting a V-Groove.

Opening Adjustment 

Select this topic to see information about the Opening Adjustment which adjusts the size of the object.

Rotation 

Select this topic to see information about Rotation which corrects for Swoops and Flares in non-oval objects.

Oval Rotation 

Select this topic to see information about the Oval Rotation which corrects for Feathers and Bumps in oval objects.

Other Cartridge Adjustments  

Select this topic to see information about Other Cartridge Adjustments section which contains adjustments for V-Grooves and the non-blade cartridge objects.

Width Adjustment (V-Groove)

Select this topic to see information on adjusting the V-Groove width if it is cutting too wide or too narrow.

Outside Rotation (V-Groove) 

Select this topic to see information on adjusting for a Swoop or Flare on the outside cut of the Non-Oval V-Groove.

Inside Rotation (V-Groove) 

Select this topic to see information on adjusting for a Swoop or Flare on the inside cut of the Non-Oval V-Groove.

Outside Oval Rotation (V-Groove)  

Select this topic to see information on adjusting for a Feather or Bump on the outside cut of an Oval V-Groove.

Inside Oval Rotation (V-Groove)  

Select this topic to see information on adjusting for a Feather or Bump on the inside cut of an Oval V-Groove.

Horizontal Adjustment (Tool Specific) 

Select this topic to see information on adjusting the Horizontal placement for the Deboss, Pen or Vinyl tool object.

Vertical Adjustment (Tool Specific) 

Select this topic to see information on adjusting the Vertical placement for the Deboss, Pen or Vinyl tool object.

Depth Setting (Tool Specific) 

Select this topic to see information on entering the optimum Blade Depth for the Deboss, Pen or Vinyl tool.

Corner Pause (ms) (Tool Specific)  

Select this topic to see information on entering the number of milliseconds to Pause in the corners when applying the Deboss, Pen or Vinyl tools to the matboard.

Overshoot (Tool Specific) 

Select this topic to see information on adjusting how much to Overshoot past the end of the segment for the Deboss, Pen or Vinyl tools. This is similar to an Overcut.

Plunge (Tool Specific) 

Select this topic to see information on adjusting whether to Plunge or UnPlunge between segments of an object when doing a Deboss, Pen or Vinyl object.

Install Pen  

Select this topic to see information on the Install Pen utility used to calibrate the system for different pens.

Configuration Map  

Select this topic to see information on the Configuration Map which maps out the Backups and Overcuts for the Current Bevel Type.

Quick Calibration 

Select this topic to see information on the Quick Calibration which walks through making sure the opening is the right size, cut in the right place, then shows how to adjust the backups and overcuts and correct for flares and swoops.

Bevel Type Cutting Direction 

Select this topic to see information on the Cutting Direction for each of the bevel types.