Lesson Eleven: Rotate Starburst within Trace

Click Ctrl + A to select all objects on the design. Optionally, click Edit > Select All.

Click the Edit radio button on the Trace and Draw Tab.

On the Rotate Degrees field, enter 30*.

*See Determining the Degree of Rotation for information on how to determine the optimum degree of rotation for your particular CutArt.

Click the Left < Rotate button.

The CutArt will Rotate.

Turn on the Dynamic Outsides if the rotated CutArt falls outside the edges of the mat.

Save the CutArt. 

You will get a message stating that this design contains objects that do not have an assigned Bevel Type.

• This refers to the Alignment Lines and Arcs that we didn't Trace.

Click Yes that you wish to continue.

The CutArt is saved.

Load the CutArt into the Design editor.

Cut the CutArt.

Since it is a Deboss design, you can also size it much smaller if desired without worrying about Overcuts and Backups

Optionally, you can also bring the CutArt straight to the Cut Preview from Trace.

The Starburst design is completed.