Exterior Backup on Creases: FrameShop Configurations Screen
Exterior Backup on Creases | |
---|---|
The Exterior Backup is where the cartridge backs up before initially plunging onto the matboard. | The Exterior Backup Field Controls Where the Cartridge Backs up Before Plunging into the Matboard on the Exterior Cuts of Non-Oval Crease Lines |
Current Crease Bevel Type | |
---|---|
Make sure to select the Crease Cartridge Tab before making adjustments.Â
| Select the Desired Bevel Type From the Bevel Type Dropdown Control |
Green Arrow on the Configurations Screen | |
---|---|
The Exterior Backup is displayed on the Configuration Map and on the associated field as a green arrow. | |
Check against the Configuration Map of the Crease Cartridge to determine specifically which cuts are the Exterior Backups. |
Crease Exterior Backup Too Long | |
---|---|
This is viewed from the front of the mat. If the Exterior Backup plunges the cartridge too soon, it makes the exterior backup too long. | |
Decrease the Exterior Backup. | |
The corners will now meet up properly. | |
When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. |
Crease Exterior Backup Too Short | |
---|---|
This is viewed from the front of the mat. If the Exterior Backup plunges the cartridge too late, it makes the exterior backup too short. | |
Increase the Exterior Backup. | |
The corners will now meet up properly. | |
When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. |
Â