This FrameShop Online Help System is for an older Version of FrameShop.
The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw
If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.
What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ
FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw
Configuration Map: FrameShop Configurations Screen
- dani.simmonds
Configurations Map |
|---|
The Configuration Map is the mapping diagram that displays the internal and external backups and overcuts for the selected Current Bevel Type in the current Cartridge Type Tab. The arrows display the cutting direction, and are color coordinated to match up with the backup and overcut fields. The maps are displayed from the front side of the matboard. |
Compare the Last Mat Cut to the Configuration Map | |
|---|---|
Look at the front of the last mat you have cut, in the same orientation in which it was cut. Use the Configuration Map to determine the problem area. |  Configuration Map Displays the Backups and Overcuts of the Current Bevel Type |
In this example, compare the lines that are too long to the lines on the Configuration Map. |  Compare the Backups and Overcuts in the Map to the Mat You Just Cut |
These long lines are the Exterior Backups, which are displayed on the Configuration Map as Green Arrows. | |
Decrease the Exterior Backup in the Configurations by a couple of clicks, click OK, and do a test cut. | |
When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. | |