This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw


Crease Configurations: FrameShop Configurations Screen

Crease Cartridge

Crease Cartridge

The Crease Cartridge creases the material to make folding it easier when making Boxes.

Crease on Box Design and Cartridge

Crease Tab

Crease Tab

Below is a list of support documentation for editing the configurations of the Crease Cartridge on the Crease Tab.

 

Select the Desired Bevel Type to Edit from the Current Bevel Type Dropdown Control

This is viewed from the front of the mat. Select this topic to see information on editing the Exterior Backup.

This is viewed from the front of the mat. Select this topic to see information on editing the Exterior Backup.

This is viewed from the front of the mat. Select this topic to see information on editing the Exterior Overcut.

This is viewed from the front of the mat. Select this topic to see information on editing the Exterior Overcut.

This is viewed from the front of the mat. Select this topic to see information on editing the Opening Adjustment.

Select this topic to see information on editing with the Troubleshooting utility to make quick edits to the Configurations for a single object on the Cutting Preview. 

Set Box Defaults

Set Box Defaults

Set up the Box Defaults for the Crease cartridge in the Admin Editor section of the software.