This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw

Opening Adjustment on Crease: FrameShop Configurations Screen

Owned by dani.simmonds
Last updated: Jan 14, 2022
3 min read

Opening Adjustment for Crease

Opening Adjustment for Crease

Adjust the Opening Adjustment if the Crease is the wrong size. 

Opening Adjustment Controls the Width of the Crease

Current Bevel Type

Current Bevel Type

Select the desired Cartridge Tab and then the bevel type you want to edit from the Current Bevel Type dropdown control before making adjustments. The Crease is automatically applied from the front of the mat, so you do not need to select Crease-Front of Mat.

  • Crease

Select the Desired Bevel Type From the Bevel Type Dropdown Control

Crease Size too Big

Crease Size too Big

The Crease is too big.

Decrease the Opening Adjustment.

The object will now be the correct size.

When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Crease Size too Small

Crease Size too Small

The Crease is too small.

Increase the Opening Adjustment.

The object will now be the correct size.

When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Opening Adjustment in the Troubleshooting Screen

Opening Adjustment in the Troubleshooting Screen

Alternatively, adjust the Opening Adjustment in the Troubleshooting Screen by entering the measured height and width of the tool line into the appropriate fields and clicking the Calc Opening Adjustment button. Make sure that only the Crease is present on the screen, otherwise the Troubleshooting Button will be grayed out.