This FrameShop Online Help System is for an older Version of FrameShop.
The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw
If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.
What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ
FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw
Pen Configurations: FrameShop Configurations Screen
- dani.simmonds
Pen Cartridge | |
|---|---|
The Pen Cartridge draws onto the matboard with the selected pen. |  Pen Opening and Cartridge |
Pen Tab | |
|---|---|
Select this topic to see information on editing the configurations for the Pen Cartridge on the Pen Tab. Select the specific Pen to edit from the Cartridge dropdown control. Note that each pen has its own set of configurations. Below is a list of support documentation for editing the configurations of the Pen Cartridge on the Pen Tab. |  Select the Desired Pen Type to Edit from the Current Bevel Type Dropdown Control |
This is viewed from the front of the mat. Select this topic to see information on editing the Pen Horizontal Adjustment. | |
This is viewed from the front of the mat. Select this topic to see information on editing the Pen Vertical Adjustment. | |
This is viewed from the front of the mat. Select this topic to see information on editing the Pen Opening Adjustment. | |
Select this topic to see information on editing the Pen Depth Setting. | |
Select this topic to see information on editing the Pen Corner Pause. | |
This is viewed from the front of the mat. Select this topic to see information on editing the Pen Overshoot. | |
This is viewed from the front of the mat. Select this topic to see information on editing the Pen Overshoot. | |
Select this topic to see information on editing the Plunge between segments. | |
Select this topic to see information on configuring different pens with the Install Pen calibration utility. | |
Select this topic to see information on the Troubleshooting utility to make quick edits to the Configurations for a single object on the Cutting Preview. | |
Set Pen Defaults | |
|---|---|
Set up the Pen Defaults in the Admin Editor section of the software. | |