This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw


Outside Cut Options: FrameShop Cut Preview Screen

Outside Cut Options

Outside Cut Options

Use the Outside Cut Options dropdown control to select how the outside of the mat is cut for the CMC Z1 and Z (9000z).

Outside Cut Options

Select the desired outside cut option from the Outside Cut Options dropdown control. 

Off: Outside Cut Option

Select this topic to see information on the Off: Outside Cut Option.

Shared Edge: Outside Cut Option

Select this topic to see information on the Shared Edge: Outside Cut Option.

Full: Outside Cut Option

Select this topic to see information on the Full: Outside Cut Option.

As Designed: Outside Cut Option

Select this topic to see information on the As Designed: Outside Cut Option.

The same Outside Cut Options are available on the Advanced Outside Options screen from the Cut Mode dropdown control.

Click the Set Advanced Options button on the Cut Preview screen.

On the Advanced Outside Options screen, make the desired selection from the Cut Mode dropdown control.

Click OK.