Full: Outside Cut Option: FrameShop Cut Preview Screen

Cut the Full Outside Edge

Cut the Full Outside Edge

Select Full from the Outside Cut Options dropdown control to cut the full outside edges of the design on the CMC Z1 and Z (9000z).

Select Full from the Outside Cut Options dropdown control to cut the complete outside edge of the design.

When tiling mats, it will cut out the complete outside edge of each design.

If you have Remnant Trimming on, it will also cut off the scrap edge.

Advanced Outside Options

The same Outside Cut Options are available on the Advanced Outside Options screen from the Cut Mode dropdown control.

On the Advanced Outside Options screen, set the Cut Mode to Full. The Cut Mode matches the selections from the Outside Cut Options as described above.

The full outside edge of the design or tiled designs will be cut.

If you have Remnant Trimming on, it will also cut off the scrap edge.

Set the Default for Cutting the Outside

Set the Default for Cutting the Outside
The default setting for Cutting the Outside can be set in the Admin > Editor section.

Set the Default for 90 Degree Outside Cut

Set the Default for 90 Degree Outside Cut
The default setting for 90 Degree Outside can be set in the Admin > Cutting section.

Set the Default for the Advanced Options

Set the Default for the Advanced Options
The default setting for the Advanced Options can be set in the Admin > Cutting section.

Set the Default for the Cut Mode

Set the Default for the Cut Mode
The default setting for the Cut Mode can be set in the Admin > Cutting section.