This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw


Off: Outside Cut Option: FrameShop Cut Preview Screen

Not Cutting the Outside

Not Cutting the Outside

Select Off from the Outside Cut Options dropdown control to not cut the outside of the mat on the CMC Z1 and Z (9000z).

Select Off from the Outside Cut Options dropdown control.

The outside of the mat will not be cut. 

Optionally, click the Cut the Outside Toggle to Off.

The outside of the mat will not be cut. 

The same Outside Cut Options are available on the Advanced Outside Options screen from the Cut Mode dropdown control.

Click the Set Advanced Options button on the Cut Preview screen.

 

On the Advanced Outside Options screen, set Cut Mode to Off. The Cut Mode matches the selections from the Outside Cut Options as described above.

Click OK.

 

The outside of the mat will not be cut.

Set the Default for Cutting the Outside 

Set the Default for Cutting the Outside 

The default setting for Cutting the Outside can be set in the Admin > Editor section.

Set the Default for the Advanced Options

Set the Default for the Advanced Options

The default setting for the Advanced Options can be set in the Admin > Cutting section.

Set the Default for the Cut Mode

Set the Default for the Cut Mode

The default setting for the Cut Mode can be set in the Admin > Cutting section.