This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw


Line Tool: FrameShop Trace Editor

Line Tool

Line Tool

The Line tool will draw a two-point line. 

Drawing a Line

Drawing a Line

Click the Line button.

Click to place each of the two points: start and end point.

  • Left-click sets the point under the cursor..

  • Right-click snaps to the nearest point.

  • Hold down the CTRL key to draw in Ortho mode; i.e., only horizontally/vertically.

Continuous Drawing

Continuous Drawing

If Continuous Drawing has been selected under Options, the lines will keep drawing until you select another tool or hit the Esc key.

Auto Align Circuits

Auto Align Circuits

If Auto Align Circuits has been selected, you will see blue highlights in the form of lines and circles when the cursor is aligned with another control point, end point or center point of another object on the design as you are drawing. 

This can aid when drawing with the current tool if you need it to be aligned with other objects in the design.

If is too distracting while working on the current design, this can toggled off under Options.

Changing a Line into an Arc

Changing a Line into an Arc

The two-point line contains a center point which can be dragged (move point) to turn the line into an Arc.