This FrameShop Online Help System is for an older Version of FrameShop.
The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw
If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.
What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ
FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw
Opening Adjustment on Deboss: FrameShop Configurations Screen
Opening Adjustment for Deboss | |
---|---|
Adjust the Opening Adjustment if the Deboss is the wrong size. | Opening Adjustment Controls the Width of the Deboss |
Current Bevel Type | |
---|---|
Select the desired Cartridge Tab and then the bevel type you want to edit from the Current Bevel Type dropdown control before making adjustments. The Deboss is automatically applied from the front of the mat, so you do not need to select Deboss-Front of Mat.
| Select the Desired Bevel Type From the Bevel Type Dropdown Control |
Deboss Size too Big | |
---|---|
The Deboss is too big. | |
Decrease the Opening Adjustment. | |
The object will now be the correct size. | |
When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. |
Deboss Size too Small | |
---|---|
The Deboss is too small. | |
Increase the Opening Adjustment. | |
The object will now be the correct size. | |
When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. |
Opening Adjustment in the Troubleshooting Screen | |
---|---|
Alternatively, adjust the Opening Adjustment in the Troubleshooting Screen by entering the measured height and width of the tool line into the appropriate fields and clicking the Calc Opening Adjustment button. Make sure that only the Deboss is present on the screen, otherwise the Troubleshooting Button will be grayed out. |