Check out our new How To section at: How To...

Troubleshooting Oval V-Grooves

Owned by dani.simmonds
Aug 19, 2024
4 min read

Adjusting Oval V-Grooves

Adjusting Oval V-Grooves

  • Select which part of the V-Groove to edit (Outside, Inside, Both) by clicking the desired radio-buttons between the Less Feather and Less Bump sections.

  • Select which part of the object to edit by clicking the Less Feather or Less Bump buttons.

  • If the Outside cut of the Oval V-Groove has a Feather, select Less Feather.

  • If the Outside cut of the Oval V-Groove cuts with a Bump, select Less Bump.

  • If the Inside cut of the Oval V-Groove has a Feather, select Less Feather.

  • If the Inside cut of the Oval V-Groove cuts with a Bump, select Less Bump.

  • For Additional Information:

  • See Outside Oval Rotation for adjusting for a Feather or a Bump in the outside cut of an Oval V-Groove.

  • See Inside Oval Rotation for adjusting for a Feather or a Bump in the inside cut of an Oval V-Groove.

A Feather in the Outside cut of an Oval V-Groove is a Fringe of material left behind where the cut started and ended on the Outside cut of the Oval V-Groove.

If the Outside cut of the Oval V-Groove has a Feather, Increase the Outside Oval Rotation.

The Oval Rotation for V-Grooves controls for Feathers and Bumps on an Oval V-Groove.

Feather on the Outside Cut of the Oval V-Groove
Outside Oval Rotation for V-Grooves

See: Outside Oval Rotation for V-Grooves Configurations

A Bump in the Outside cut of an Oval V-Groove is a Lump of material left behind where the cut started and ended on the Outside cut of the Oval V-Groove.

If the Outside cut of the Oval V-Groove cuts with a Bump, Decrease the Outside Oval Rotation.

The Oval Rotation for V-Grooves controls for Feathers and Bumps on an Oval V-Groove.

See: Outside Oval Rotation for V-Grooves Configurations

A Feather in the Inside cut of an Oval V-Groove is a Fringe of material left behind where the cut started and ended on the Inside Cut of the Oval V-Groove.

If the Inside cut of the Oval V-Groove has a Feather, Decrease the Inside Oval Rotation.

The Oval Rotation for V-Grooves controls for Feathers and Bumps on an Oval V-Groove.

See: Inside Oval Rotation for V-Grooves Configurations

A Bump in the Inside cut of an Oval V-Groove is a Lump of material left behind where the cut started and ended on either the Inside Cut of the Oval V-Groove.

If the Inside cut of the Oval V-Groove cuts with a Bump, Increase the Inside Oval Rotation.

The Oval Rotation for V-Grooves controls for Feathers and Bumps on an Oval V-Groove.

See: Inside Oval Rotation for V-Grooves Configurations

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.