Editing the 45 Degree Front Cartridge Configurations

Editing the 45 Degree Front Blade Cartridge Configurations

Editing the 45 Degree Front Blade Cartridge Configurations

  • The 45° Front metal orange blade cartridge is designed to cut 45° bevels on standard 4-ply matboard from the front of the mat.

  • The 45° Front metal orange blade cartridge is labeled with a 45° with a Triangle on the end.

    • The 45° front blade cartridge does not support blade depths above 16.

45FrontMetalBevelOpening70800.png
The 45 Degree Front Cartridge Cuts a 45 Degree Bevel into the Matboard From the Front of the Mat
The Configurations Screen is Where to Adjust The Configurations of Bladed or Non-Bladed Cartridges

Cutting from the Front will cut with the face of the mat toward the operator, and can be selected on the Cut Preview.

  • On the Configurations screen the Current Bevel Type dropdown control will display the bevel types in this manner:

    • Cut from the Back bevel type names will be displayed with no further label; i.e., Normal Bevel.

    • Cut from the Front bevel type names will be displayed with a Front label; i.e., Normal Bevel-Front of Mat.

    • V-Grooves have their own selection on the list.

If you are cutting an element that must be applied to the front of the mat, such as a V-Groove or Pen design, any openings on that layer will also cut from the front and use the Front of Mat configuration item; i.e., Normal Bevel-Front of Mat.

So if you are having problems with a Normal Bevel cut on the same layer as a V-Groove, make sure you select Normal Bevel-Front of Mat to edit the configurations for that opening.