/
Changing the Blade on the Vinyl Cartridge

Changing the Blade on the Vinyl Cartridge

Changing the Blade on the Vinyl Tool Cartridge

Changing the Blade on the Vinyl Tool Cartridge

  • The Vinyl Cartridge uses a special blade to cut the Vinyl which has been temporarily adhered to the matboard to create the design.

  • The Vinyl is labeled in the software with a thin Vinyl Blade Icon.

Vinyl Cartridge Icon

Installing the Vinyl Blade

  • Open up the package of blades and carefully pull off the rubber cover from the tip of the blade. 

  • Holding the cartridge in one hand, push on the plunge rod on the back of the cartridge to expose the blade channel. 

  • Carefully remove the blade from the cartridge by grasping it and pulling it straight out.

Installing the Vinyl Blade into the Vinyl Cartridge
  • Insert the fresh blade into the channel with the point and edge of the blade sticking out of the channel.

Related content

Change the Vinyl Cartridge Blade: CMC 9000 and the Z Series
Change the Vinyl Cartridge Blade: CMC 9000 and the Z Series
More like this
Installing the Blade on the Vinyl Tool Cartridge: CMC Z1, Z (9000z) and 9000
Installing the Blade on the Vinyl Tool Cartridge: CMC Z1, Z (9000z) and 9000
More like this
Change to the Vinyl Cartridge
Change to the Vinyl Cartridge
More like this
Changing to the Vinyl Tool Cartridge: CMC Z1, Z (9000z) and 9000
Changing to the Vinyl Tool Cartridge: CMC Z1, Z (9000z) and 9000
More like this
Cutting with the Vinyl Cartridge
Cutting with the Vinyl Cartridge
More like this
Editing the Vinyl Cartridge Configurations
Editing the Vinyl Cartridge Configurations
More like this