This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw

Off Cut Mode: FrameShop Cut Preview Screen

Owned by dani.simmonds
Last updated: May 25, 2021
2 min read

Off Cut Mode

Off Cut Mode

Select Off from the Cut Mode dropdown control to not cut the outside of the mat on the CMC Z1 and Z (9000z).

Click the Set Advanced Options button to access the Advanced Outside Options. 

Select Off from the Cut Mode dropdown control.

Click OK.

 

The outside of the mat will not be cut.

Optionally, click the Cut the Outside Toggle to Off to not cut the outside.

Set the Default for Cutting the Outside 

Set the Default for Cutting the Outside 

The default setting for Cutting the Outside can be set in the Admin > Editor section.

Set the Default for the Advanced Options

Set the Default for the Advanced Options

The default setting for the Advanced Options can be set in the Admin > Cutting section.

Set the Default for the Cut Mode

Set the Default for the Cut Mode

The default setting for the Cut Mode can be set in the Admin > Cutting section.Â