Driver Pack 80 Volt Hardware Replacement: CMC 8000 and 8500 Series

• The Driver Pack is the signal amplifier to the Wizard CMC and comes in several variations.

• Remove the old parts before installing the replacement parts, and return the old parts to Wizard for proper credit.

• It is important to note that if you are replacing a USB Driver Pack with a USB 80-Volt USB Driver Pack (label on the back will state if it is an 80-Volt Driver Pack), to follow the instructions “Installing the Drivers for the 80-Volt Driver Pack”.

• Power off the Driver Pack.

• Unplug the Board Cable (large Grey) from the back of the Driver Pack by turning black locking ring and pulling gently.

• Unplug the Driver Pack Power Cord.

• Unplug the USB Cable from the back of the Driver Pack.

• Return the Driver Pack to Wizard.

WARNING: The Driver Pack is HIGH VOLTAGE! No user serviceable parts are inside the Driver Pack.

• Connect the Driver Pack to the computer by plugging the USB Cable into the USB Driver Pack.

• If you were sent a replacement USB Cable, plug the new USB Cable into the Driver Pack, and the other end into the same USB Port of the Computer that the old cable was using.

• Plug the Power Cable into the back of the Driver Pack.

• Before plugging in the Board Cable (large grey), note that several of these pins are in a straight line.

• Align the plug so that the pins are aligned correctly, gently insert plug, then turn black Locking Ring until it seats itself and clicks into place.

• The replacement USB Driver Pack has been installed.

• If you are replacing a USB Driver Pack with an 80-Volt Driver Pack, follow the directions under “Installing the Drivers for the 80-Volt Driver Pack” below.

• Power on the Driver Pack.

• Make sure that you have the 5.4.1. or 5.5.1. MatDesigner CD, as the Drivers are on the CD.

• Follow the instructions on “Installing the Drivers for the 80-Volt Driver Pack”.