Enable Auto Offset: Location Tab

Enable Auto Offset: Location Tab

Enable Auto Offset: Location Tab

  • Select Auto Offset checkbox to move the design up and over on the matboard to avoid the Clamp area on the Cut Preview.

  • Click on the design to select it.

  • Check the Auto Offset checkbox.  

  • Enter the distance to move the design in the X Origin field; the Y Origin field uses the same numerical value. 

  • It will move the lower left corner of the design to the new X/Y Position and it will display Dodge on the bottom of the screen.

  • This feature is also turned on by selecting Full from the Outside Cut Options dropdown control.

Auto Offset
Select Auto Offset Checkbox to Move the Design up and over on the Matboard to Avoid the Clamp Area on the CMC Z1 and Z (9000z)