/
Enable Auto Clamp Offset
This FrameShop Online Help System is for an older Version of FrameShop.
The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw
If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.
What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ
FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw
Enable Auto Clamp Offset
- dani.simmonds
Owned by dani.simmonds
Enable Auto Clamp Offset | |
|---|---|
The Auto Clamp Offset moves the design up and over on the matboard to avoid the clamp area on the CMC Z1 and Z (9000z), similar to the Rail Dodge. This overcomes the border limitation of 1.25"/3.2 cm when not cutting the outside. This feature is also turned on by selecting Full from the Outside Cut Options dropdown control. |  |
, multiple selections available,
Related content
Enable Auto Offset: Location Tab
Enable Auto Offset: Location Tab
More like this
Cut the Outside: FrameShop Cut Preview Screen
Cut the Outside: FrameShop Cut Preview Screen
More like this
Matboard: Not Cut the Outside Editor Properties Tab
Matboard: Not Cut the Outside Editor Properties Tab
More like this
Set Advanced Options: Cut Preview
Set Advanced Options: Cut Preview
More like this
Matboard Properties: FrameShop Design Editor
Matboard Properties: FrameShop Design Editor
More like this
Outside Cut Off: Cut Mode Advanced Options
Outside Cut Off: Cut Mode Advanced Options
More like this