Shared Edge Definition
This feature is only available for the CMC Z1, Z(9000z), 9000 and 8000 Plus.
Make sure that the Spacing between the designs is set to Zero (0).
For a single opening, it cuts only the top and right sides, leaving the factory edge on the left and bottom.
NOTE: The Outside cut direction and cut order will differ between cutting using the Shared Edge and Full.
Keep this in mind when adjusting the Backups and Overcuts on the Configurations.
See Using the Backup and Overcut Display on the Cut Preview for Troubleshooting the Backups and Overcuts displayed on the Cut Preview.
Shared Edge