Troubleshooting Software
This screen shows resolutions to the most common Software questions.
Contents:
- Troubleshooting Design Issues
- Border Order on the New Openings Screen has Changed
- How to Subscribe to a Vendor
- Layer Direction Seems to Have Changed
- New Openings Screen no Longer Opens
- Opening/Outside Size Fields have Swapped Places on the New Openings Screen
- Opening Sizes are Displayed/No Longer Displayed on the Openings
- Outside Dimensions Keep Changing While Editing the Design
- Memory Errors Loading an Image File
- The Wrong Layer is Snapping to the Guides
- This Design Contains Content that is Smaller than its Recommended Minimum Size
- Troubleshooting Configuration Issues
- Adjusting Cutting Issues or Application of the Non-Blade Cartridges
- Adjust the V-Groove Width
- Backup on Opening is too Long/Short
- Backup on V-Groove is too Long/Short
- Feather/Bump in the Oval
- Feather/Bump in the Oval V-Groove
- Calibrate the Pen Cartridge
- Examples of the Different Bevel Types the CMC Can Cut
- Hook in the Corner
- Making Changes to the Configurations and Nothing is Happening
- Non-Blade Cartridge is Applied too Deep/Shallow
- Non-Blade Cartridge Misaligned Horizontally
- Non-Blade Cartridge Misaligned Vertically
- Opening is too Large/Small
- Openings are Misaligned Horizontally
- Openings are Misaligned Vertically
- Overcut on Opening is too Long/Short
- Overcut on V-Groove is too Long/Short
- Overshoot on Non-Blade Cartridges is too Long/Short
- Swoops/Flares on an Opening
- Swoops/Flares on a V-Groove
- Troubleshooting Cutting Issues
- Troubleshooting: How to Set the Default Setting for...
- Default Values for Design Creation
- Defaults for the Borders
- Defaults for Font Kerning/Tracking
- Default Horizontal/Vertical Spacing for Array Designs
- Default Number of Layers
- Default Offset Distance for Placing V-Groove, Deboss, Pen or Crease from a Selected Object
- Default Opening Size
- Default Outside Size
- Default Pen Cartridge Settings
- Default for Positioning Toggle
- Default Reveal Values
- Default to Fractions or Decimals
- Default Standard Sizes
- Defaults for Cutting Preferences
- Default to Auto Offset the Design into the Cutting Area
- Default Blade Depths
- Default to Continuously Cut the Current Layer
- Default to Cut/not Cut the Outside
- Default to Cut From the Front/Back of the Mat
- Default Cartridge Selection for Cutting From the Front
- Default to Cut Outside with the 45/90 Degree Cartridge
- Default Cut Speed for Dense Material
- Default to Display/Hide the Previous Cuts
- Default for Full Cut Mode on Outside Cut
- Default for Shared Edge Cut Mode on Outside Cut
- Default to Cut the Outside As Designed
- Default Setting for Remnant Trimming
- Default Settings for Tiling
- Default Setting for Unit of Measure
- Default Settings for the Box Software
- Default Settings for Visualize
- Default Values for Design Creation