This FrameShop Online Help System is for an older Version of FrameShop.+">This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 36 Next »

Pen Cartridge

The Pen Cartridge draws onto the matboard with the selected pen.

Pen Tab

Select this topic to see information on editing the configurations for the Pen Cartridge on the Pen Tab.

Select the specific Pen to edit from the Cartridge dropdown control. Note that each pen has its own set of configurations.

Below is a list of support documentation for editing the configurations of the Pen Cartridge on the Pen Tab.

Pen is Applied to the Wrong Place Horizontally 

This is viewed from the front of the mat. Select this topic to see information on editing the Pen Horizontal Adjustment.

Pen is Applied to the Wrong Place Vertically 

This is viewed from the front of the mat. Select this topic to see information on editing the Pen Vertical Adjustment.

Pen is the Wrong Size

This is viewed from the front of the mat. Select this topic to see information on editing the Pen Opening Adjustment.

Pen Applied at the Wrong Depth

Select this topic to see information on editing the Pen Depth Setting.

Pen Cartridge Tears the Mat

Select this topic to see information on editing the Pen Corner Pause. 

Pen Lines are too Long

This is viewed from the front of the mat. Select this topic to see information on editing the Pen Overshoot.

Pen Lines are too Short 

This is viewed from the front of the mat. Select this topic to see information on editing the Pen Overshoot.

Set Pen to Plunge Between Pen Line Segments

Select this topic to see information on editing the Plunge between segments.

Calibrating Different Pens

Select this topic to see information on configuring different pens with the Install Pen calibration utility.

Troubleshooting Button

Select this topic to see information on the Troubleshooting utility to make quick edits to the Configurations for a single object on the Cutting Preview.

Set Pen Defaults

Set up the Pen Defaults in the Admin Editor section of the software.

  • No labels