Driver Pack 80 Volt Hardware Replacement: CMC 8000 and 8500 Series

The Driver Pack

The Driver Pack
The Driver Pack is the signal amplifier to the Wizard CMC and comes in several variations. Remove the old parts before installing the replacement parts, and return the old parts to Wizard for proper credit.	80-Volt Driver Pack
It is important to note that if you are replacing a USB Driver Pack with a USB 80-Volt USB Driver Pack (label on the back will state if it is an 80-Volt Driver Pack), to follow the instructions “Installing the Drivers for the 80-Volt Driver Pack” at the end of this document.	80-Volt Driver Pack Plugged In

Removing the External Driver Pack/USB Driver Pack

Removing the External Driver Pack/USB Driver Pack
Power off the Driver Pack by flipping the toggle on back to “0”.

Installing the USB Driver Pack/80-Volt Driver Pack

Installing the USB Driver Pack/80-Volt Driver Pack

Installing the Drivers for the 80-Volt Driver Pack

Installing the Drivers for the 80-Volt Driver Pack

Windows 8-10 Signed Driver Set-up Procedure

Windows 8-10 Signed Driver Set-up Procedure

Identifiers

Identifiers

New Hardware Wizard - Install 80V Drivers

New Hardware Wizard - Install 80V Drivers

New Hardware Wizard - Install USB Serial Port Adapter (USB Controller)

New Hardware Wizard - Install USB Serial Port Adapter (USB Controller)

Check the Version Number

Check the Version Number

If running 5.5.1 or later

If running 5.5.1 or later

If running 5.4.1

Knowledge Base