Emergency Stop Button: CMC Z Series

Owned by dani.simmonds
Last updated: Jun 04, 2024
1 min read

Aborting a Cut

Aborting a Cut

  • The Emergency Stop Button is located on the lower left lower corner of the board on the Control Panel.

  • Hit the Emergency Stop Button to immediately abort the current cut and disengage the motors. 

 

Hit the Emergency Stop Button to Abort the Cut

Restart After Aborting a Cut

Restart After Aborting a Cut

  • To restart cutting, pull out the Emergency Stop Button and close and reopen the FrameShop software.

  • You will be asked to Align the Head before cutting again. 

  • See Align the Head for instructions on how to Align the Head.

Pull Out the Emergency Stop Button and Realign the Head