AirGlide Acrylic Cartridge

• Loosen the Cartridge Release knob.

• Pull out the current Cartridge from the cutting head.

• Locate the Acrylic Cartridge.

Insert the Acrylic Cartridge keeping the protruding Acrylic Cartridge Depth Adjustment Thumbwheel on the right side.

NOTE: It is not necessary to remove the protective coating from Acrylic before using the Acrylic Cartridge.

• Tighten the Cartridge Release knob to lock it in place.

• Loosen the Cartridge Release knob.

• Loosen the 1/16” set screw on the Blade Depth Adjustment Thumbwheel.

• Turn the Blade Depth Adjustment Thumbwheel to adjust the cartridge depth.

• The Blade Depth Adjustment Thumbwheel controls the depth of the acrylic/blade/glass cutter by impeding how far the cartridge can be inserted into the head.

• Note that the (Optional) Composite Cartridge has no depth adjustment. See the desired tool for optimum depth:

• Push the cartridge into the cutting head to re-measure how far the cartridge tool is located in reference to the material being cut.

• Once the desired blade depth is set, tighten but don’t over-tighten the 1/16” set screw on the blade depth thumb wheel to lock it into place.

• Press the cartridge into the head and tighten the Cartridge Release knob.

• The Acrylic Cartridge depth should extend the scoring stylus to the mid-point of the material thickness being scored.