Bevel Type: Drop Selection: Trace
Bevel Type Drop Selection | |
---|---|
The Normal Bevel Drop is created by cutting into the fallout surface with the blade angled at 45°/52°, thereby slanting the bevel away from the fallout surface. The matboard core is visible from the front. The Drop is one of the categories within certain opening styles, like the initial section cut of an Open V-Groove. However, it cannot be chosen as a standalone bevel type within Designer. The Bevel Type refers to the angle at which the blade cuts the surface of the matboard when it deviates from the 90° right angle cut. Select Normal Drop or Normal Drop-Front of Mat from the Current Bevel Type dropdown control to edit this configuration. Normal Drop Normal Drop Configurations See: 45 Degree Normal Bevel Drop Configurations See: 45 Degree Plus Normal Bevel Drop Configurations See: 45 Degree Front Normal Bevel Drop Configurations | |
Specialty
A Cartridge is the physical component that holds the Blade, Deboss Stylus, Pen or other application tool. The Pen Cartridge is used to draw onto the surface of the matboard on the CMC to create a design. You can Pen Designs, CutArts, LetterMats and TTFs. The Deboss cartridge stylus presses onto the surface of the matboard to create a subtle design. There are three Deboss stylus sizes: Wide, Medium, Thin. In addition to Template Shapes, you can also Deboss CutArts, LetterMats and TTFs. The Vinyl Cartridge uses a special blade to cut the Vinyl which has been temporarily adhered to matboard to create the design. |