Crease Overcut is Too Long

• The Overcut controls where the cartridge Retracts from the Matboard.

  • If the Overcut is cut Too Long, Decrease the Overcut.

  • If the Overcut is cut Too Short, Increase the Overcut.

• The Overcut field is marked with a Red Arrow on the Configuration screen and the Map illustration.

Open

Crease Overcuts

Open

Crease Overcut Configurations

See: Overcut for Creases Configurations

When adjusting Configurations, click the Plus (Increase) or Minus (Decrease) button on the desired field about five times.

Click OK and do another test cut.

Continue making adjustments until the desired outcome is achieved.