Check out our new How To section at: How To...

Save as Path

Owned by dani.simmonds
Last updated: yesterday at 4:20 pm
2 min read

Save as Path

Save as Path

  • It is suggested that as you work, save the design as a Path.

    • This will allow you to save the design as you go without being required to trace the design.

    • You can save the design and reload the Path file into Trace at a later time and continue on with the lesson.

    • Many of these lessons start with objects created in Design.

    • See the Design Editor for more information on placing and aligning objects, etc. 

A Path (.wpx) is a drawn Vector graphic path in Trace which is defined by a Start and End point, which may contain other Points, Curves, and Angles.

The Paths are independent of resolution, which means they can be resized without losing detail.

The Path file format in Trace will save all of the Vector elements of the design as you work, whether it is Traced or not. 

When the design is completed, save it as a CutArt to load into Designer.