This FrameShop Online Help System is for an older Version of FrameShop.+">This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 26 Next »

Deboss Wide Cartridge

The Blue Deboss Wide Cartridge presses a wide stylus into the matboard to create a subtle design.

Select the Deboss Wide Cartridge Type

Select the Deboss Tab on the Configurations screen.  

Select the Wide-Blue cartridge from the Cartridge dropdown control.

Select the Area of Concern for Wide Deboss Below:

Be sure to select the Deboss Wide from the Current Bevel Type dropdown control.

Deboss-Wide is Applied to the Wrong Place Horizontally

Select this topic to adjust the Horizontal Adjustment.

Deboss-Wide is Applied to the Wrong Place Vertically 

Select this topic to adjust the Vertical Adjustment.

Deboss-Wide is the Wrong Size

Select this topic to adjust the Opening Adjustment.

Deboss-Wide Applied at the Wrong Depth

Select this topic to adjust the Depth Setting.

Deboss-Wide Cartridge Tears the Mat 

Select this topic to adjust the Corner Pause. 

Deboss-Wide Lines are too Long

Select this topic to adjust the Overshoot.

Deboss-Wide Lines are too Short 

Select this topic to adjust the Overshoot.

Deboss-Wide Set to Plunge Between Segments

Select this topic to adjust the Plunge between segments.

Troubleshooting Button 

Use the Troubleshooting utility to make quick edits to the Configurations for a single object on the Cutting Preview. 

  • No labels