Opening Adjustment on Deboss: FrameShop Configurations Screen

Adjust the Opening Adjustment if the Deboss is the wrong size.

Select the desired Cartridge Tab and then the bevel type you want to edit from the Current Bevel Type dropdown control before making adjustments. The Deboss is automatically applied from the front of the mat, so you do not need to select Deboss-Front of Mat.

• Deboss Wide - Blue

• Deboss Medium - Red

• Deboss White - Thin

The Deboss is too big.

Decrease the Opening Adjustment.

The object will now be the correct size.

When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved.

The Deboss is too small.

Increase the Opening Adjustment.

The object will now be the correct size.

When making adjustments, click either the minus or plus button (-/+) at the end of the desired field about five or six times in the direction indicated. Click OK and do a test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved.

Alternatively, adjust the Opening Adjustment in the Troubleshooting Screen by entering the measured height and width of the tool line into the appropriate fields and clicking the Calc Opening Adjustment button. Make sure that only the Deboss is present on the screen, otherwise the Troubleshooting Button will be grayed out.