This FrameShop Online Help System is for an older Version of FrameShop.+">This FrameShop Online Help System is for an older Version of FrameShop.

The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw

If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.

What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ

FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 25 Current »

Vertical Home

The Vertical Home defines the global vertical placement of objects cut with the blade cartridges.

Select the Area of Concern for the Vertical Home Below:

Vertical Home for Openings

This is viewed as it cut on the machine, i.e., from the back if cutting from the back, or from the front if cutting from the front.

Select this topic to see information on editing the opening if it is cutting too high or too low Vertically when you are not cutting the outside of the mat.

Vertical Home for V-Grooves

This is viewed from the front of the mat. Select this topic to see information on editing the V-Groove if it is cutting too high or too low Vertically when you are not cutting the outside of the mat.

Adjusting the Vertical Position for Non-Blade Cartridges

This is viewed from the front of the mat. Select this topic to see information on editing the Vertical placement of the non-blade cartridges, (i.e., Deboss, Pen or Vinyl tools), see Vertical Adjustment.

  • No labels