This FrameShop Online Help System is for an older Version of FrameShop.
The updated 7.x FrameShop Online Help can be found here: https://wizardcutters.atlassian.net/wiki/x/hgApYw
If you are running FrameShop version FrameShop 4.1 or above you can update your software by clicking on Options then Check For Update.
What to Expect When Updating to FrameShop 7x from FrameShop 4x: https://wizardcutters.atlassian.net/wiki/x/AQDWaQ
FrameShop Installation Documents: https://wizardcutters.atlassian.net/wiki/x/_1snYw
Vertical Home for V-Grooves: FrameShop Configurations Screen
- dani.simmonds
Vertical Home for V-Grooves | |
|---|---|
The Vertical home defines the global vertical placement of objects cut with the blade cartridges, including V-Grooves. |  Adjust the Vertical Home if the V-Groove is Applied in the Wrong Place Vertically |
V-Groove Cuts too Far Up when Not Cutting the Outside: Bottom Border too Big | |
|---|---|
Adjust the Vertical home if the V-Groove is cutting too far up (as it sat on the board) when you are not cutting the outside of the mat. This is measured from the inside of the bevel to the edge of the mat. | |
This is viewed from the front of the mat. The V-Groove is cutting too far up, making the bottom border too big. |  V-Groove is Cut too Far Up |
Decrease the Vertical home. When making adjustments, click the plus or minus button at the end of the desired field about five times. Click OK and do another test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. | |
V-Groove is moved down. | |
V-Groove Cuts too Far Down when Not Cutting the Outside: Bottom Border too Small | |
|---|---|
Adjust the Vertical home if the V-Groove is cutting too far down (as it sat on the board) when you are not cutting the outside of the mat. This is measured from the inside of the bevel to the edge of the mat. | |
This is viewed from the front of the mat. The V-Groove is cutting too far down, making the bottom border too small. | |
Increase the Vertical home. When making adjustments, click the plus or minus button at the end of the desired field about five times. Click OK and do another test cut. Check the results of the cut and continue making adjustments until the desired outcome is achieved. | |
The V-Groove moves up. | |
Vertical Home Troubleshooting | |
|---|---|
Alternatively, adjust the Vertical Home on the Troubleshooting Screen. Make sure that you only have a V-Groove on the screen. | |