Cartridges Involved
This Configuration element involves the following Cartridges.
Note: Not all cartridges are available for all CMC models.
Deboss Wide Configurations
Info |
---|
|
Select the Deboss Wide Cartridge Type
Select the Deboss Tab on the Configurations screen.
Select the Wide-Blue cartridge from the Cartridge dropdown control.
Tip |
---|
|
Select the Area of Concern for Wide Deboss Below:
Be sure to select the Deboss Wide from the Current Bevel Type dropdown control.Deboss Wide Configurations |
---|
Contents: |
Problem:
The Deboss-Wide is Applied to the Wrong Place Horizontally.
Resolution:
If the Tool line is applied too far Left Horizontally, Increase the Horizontal Adjustment.
If the Tool line is applied too far Right Horizontally, Decrease the Horizontal Adjustment.
See Horizontal Adjustment for additional information.
title | Horizontal Adjustment Definition |
---|
Problem:
The Deboss-Wide is Applied to the Wrong Place Vertically.
Resolution:
If the Tool line is applied too far Up Vertically, Decrease the Vertical Adjustment.
See Vertical Adjustment for additional information.
title | Vertical Adjustment Definition |
---|
Problem:
Resolution:
If the Opening is cut too Large, Decrease the Opening Adjustment.
If the Opening is cut too Small, Increase the Opening Adjustment.
See Opening Adjustment for additional information.
Expand | ||
---|---|---|
| ||
The Opening Adjustment controls the size of the object cut or applied with non-blade cartridges. |
Problem:
Resolution:
The Non-Blade Tool is too Deep, Decrease the Depth Setting.
The Non-Blade Tool is too Shallow, Increase the Depth Setting.
See Depth Setting for additional information.
Expand | ||
---|---|---|
| ||
The Depth Setting controls the Blade Depth for the Non-Blade Tools in the Configurations. |
Problem:
Deboss-Wide Cartridge Tears the Mat.
Resolution:
The Non-Blade Tool is Tearing in the Corners of the segments, Increase the Corner Pause.
See Corner Pause for additional information.
Expand | ||
---|---|---|
| ||
The Corner Pause setting in Configurations is the amount of time, in milliseconds, to pause the application of the Non-Blade Tools between segments. |
Resolution:
Expand | ||
---|---|---|
| ||
The Overshoot controls how far past the end of the Line/Arc Segment to apply the Non-Blade Tool (Deboss, Pen or Vinyl). This is similar to the Overcut used with the Blade cartridges. |
Deboss-Wide Lines are too Short
Problem:
The Deboss-Wide Lines are too Short.
Resolution:
Expand | ||
---|---|---|
| ||
The Overshoot controls how far past the end of the Line/Arc Segment to apply the Non-Blade Tool (Deboss, Pen or Vinyl). This is similar to the Overcut used with the Blade cartridges. |
Deboss-Wide Set to Plunge Between Segments
Problem:
The Deboss-Wide Set to Plunge Between Segments.
Resolution:
The Non-Blade Tool leaves a Dot where it plunges, select Unplunge.
The Non-Blade Tool takes Too Long to apply, select Plunge.
See Plunge for additional information.
Expand | ||
---|---|---|
| ||
The Plunge function controls whether to Plunge/Unplunge between the Line/Arc Segments of an object when applying a Non-Blade Tool. |
Troubleshooting Button
Info |
---|
|
Deboss Wide Definition | |||||
---|---|---|---|---|---|
|