Page Comparison

Cartridges Involved

This Configuration element involves the following Cartridges.

Note: Not all cartridges are available for all CMC models.

Image Removed

Deboss Wide Configurations

The Blue Deboss Wide Cartridge presses a wide stylus into the matboard to create a subtle design.

Image Removed

Select the Deboss Wide Cartridge Type

Select the Deboss Tab on the Configurations screen.  

Select the Wide-Blue cartridge from the Cartridge dropdown control.

Image Removed

Select the Area of Concern for Wide Deboss Below:

Resolution:

• Adjust the Horizontal Adjustment.

• The Horizontal Home controls where the opening is cut Horizontally.

Image Removed

Deboss-Wide is Applied to the Wrong Place Vertically 

Problem:

• The Deboss-Wide is Applied to the Wrong Place Vertically.

Resolution:

Image Removed

Problem:

Resolution:

• Adjust the Opening Adjustment.

• The Opening Adjustment controls the size of the opening.

Image Removed

Problem:

Resolution:

• Adjust the Depth Setting.

• The Depth Setting sets the proper Blade Depth for the Deboss Cartridge.

Image Removed

Problem:

Resolution:

• Adjust the Corner Pause. 

• The Corner Pause controls the amount of time, in milliseconds, to pause the application of the non-blade tools in the corners to avoid tearing the mat.

Image Removed

Resolution:

• Adjust the Overshoot.

• The Overshoot controls how far past each segment the non-blade tool (Deboss, Pen or Vinyl) is applied.

Image Removed

Deboss-Wide Lines are too Short 

Problem:

• The Deboss-Wide Lines are too Short.

Resolution:

• Adjust the Overshoot.

• The Overshoot controls how far past each segment the non-blade tool (Deboss, Pen or Vinyl) is applied.

Image Removed

Deboss-Wide Set to Plunge Between Segments

Problem:

• The Deboss-Wide Set to Plunge Between Segments.

Resolution:

• Adjust the Plunge. Select this topic to adjust the Plunge between segments.

Image Removed

Troubleshooting Button 

• Use the Troubleshooting utility to make quick edits to the Configurations for a single object on the Cutting Preview. 

Image Removed