Pen Cartridge | |
|---|---|
The Pen Cartridge draws onto the matboard with the selected pen. |  |
Pen Tab | |
|---|---|
Select this topic to see information on editing the configurations for the Pen Cartridge on the Pen Tab. Select the specific Pen to edit from the Cartridge dropdown control. Note that each pen has its own set of configurations. Below is a list of support documentation for editing the configurations of the Pen Cartridge on the Pen Tab. |  |
...
Pen is Applied to the Wrong Place Vertically | |
|---|---|
This is viewed from the front of the mat. Select this topic to see information on editing the Pen Vertical Adjustment. |  |
Pen is the Wrong Size | |
|---|---|
This is viewed from the front of the mat. Select this topic to see information on editing the Pen Opening Adjustment. |  |
Pen Applied at the Wrong Depth | |
|---|---|
Select this topic to see information on editing the Pen Depth Setting. |  |
...
Set Pen to Plunge Between Pen Line Segments | |
|---|---|
Select this topic to see information on editing the Plunge between segments. |   |
Calibrating Different Pens | |
|---|---|
Select this topic to see information on configuring different pens with the Install Pen calibration utility. |   |
Troubleshooting Button | |
|---|---|
Select this topic to see information on the Troubleshooting utility to make quick edits to the Configurations for a single object on the Cutting Preview. |   |
Set Pen Defaults | |
|---|---|
Set up the Pen Defaults in the Admin Editor section of the software. |   |