Upgrade/Termination Hardware Return Instructions: CMC 9000 and the Z Series

Owned by dani.simmonds
Last updated: Sept 17, 2024
11 min read

Please Box up the Following Four Items for Return:

Please Box up the Following Four Items for Return:

Please use your original CMC box to box up the following four items into one box. If you do not have your original packaging the box the new CMC arrived in can be used.

• Board
• Gantry
• Head
• ECU/Driver Pack

Please see the following removal and repacking for each item.

Head Removal

Head Removal

Caution: Head appearance may vary from model shown, but the connections are the same. Do not pick up Head using the blade depth knob or the Head cover. Pick up the Head by holding the “D-Shaped” upper and lower Head plates.

  • If the motors are engaged, click Reset Motors Button on the Cut Preview and click OK on the release motors prompt.

Reset Motors Button

  • Press the 0 on the rocker switch on the back of the ECU to turn off the ECU.

Turn off ECU

Removing the ECU/Driver Pack

Removing the ECU/Driver Pack

Secure the Gantry

Secure the Gantry

Loosen Drive Belt

Loosen Drive Belt

Remove Stop Plate

Remove Stop Plate

Magnetic Gantry Stop

Magnetic Gantry Stop

Silver Gantry Stop Plate

Silver Gantry Stop Plate

Attaching Shipping Blocks

Attaching Shipping Blocks

Reinstall the Stop Plate

Reinstall the Stop Plate

Magnetic Gantry Stop

Magnetic Gantry Stop

Silver Gantry Stop Plate

Silver Gantry Stop Plate

Installing the Drive Belt onto the Rail

Installing the Drive Belt onto the Rail

Head Packaging

Head Packaging

Packing up the ECU/Driver Pack

Packing up the ECU/Driver Pack

Boxing up the Board

Boxing up the Board

Schedule the System Return

Schedule the System Return

Upon boxing up the CMC into one large box, please contact Christina Costilla at Wizard to schedule a pickup of the return at Christina.Costilla@wizardcutters.com 425-551-4300 x4304.