ECU Driver Installation: CMC 8500 Series and the 9000

The ECU is the signal amplifier to the Wizard CMC.
For optimum performance, drivers must be installed properly as described below.
Please have the MatDesigner 5.7.3. or greater CD in hand to install the drivers.

ECU

Installing the Wizard ECU Drivers
Put in the MatDesigner CD to Install ECU Drivers. Power off the ECU.	Turn off the ECU
Unplug the USB Cable from the ECU. It is necessary to turn off and unplug the ECU otherwise the ECU memory will not clear and the drivers installation will NOT take full effect.	Unplug the USB Cable From the ECU
Put the MatDesigner version 5.5.3. or greater CD into the CD drive. The CD will start up to the main screen. On versions 5.7.3. and previous, click Install Software then click ECU Drivers. On later versions, just click ECU Drivers.	Click Wizard ECU Drivers
On the Wizard USB Install Screen, Click Next.	Click Next
User may see a Warning Screen; click Continue Anyway.	Click Continue Anyway
After it finishes installing, Click Finish on the driver installer screen, which will return to the Install Products Screen.	Click Finish

New Hardware Found
The Found New Wizard MUST be run through TWICE. The first time installs the firmware for the ECU, the second time installs the drivers for the ECU. If you do not run through the Found New Hardware Wizard both times, the ECU may not function properly.
Plug in the USB Cable to the ECU.	Plug in the USB Cable to the ECU
Power up the ECU.	Power up the ECU
The Found New Hardware Wizard will start up. Click Next.	Click Next
The software will begin to install.	Software Will Install
User may see two Warning Screens; click Continue Anyway on both screens.	Click Continue Anyway
When the install has finished, click Finish on the Completing Found New Hardware Wizard.	Click Finish
The Found New Hardware Wizard will start up again. Repeat steps 4-7 above. When the system asks to reboot, click Cancel. We will reboot after removing the CD.

Click Exit