ECU Drivers Installation: FrameShop: CMC 8000 Series, 9000 and the Z Series

The Drivers for the ECU must be installed on the Computerized Mat Cutter (CMC) Computer. 

The Drivers will install two parts.

• The first part installs the Drivers for the ECU, and the second part installs the firmware for the ECU. 

• If both parts are not installed, the ECU may not function properly.

Power off the ECU.

Unplug the USB Cable from the ECU. 

• It is necessary to turn off and unplug the ECU, otherwise the ECU memory will not clear and the Drivers installation will NOT take full effect.

Start up the FrameShop installation to go to the Installation Main Screen.

Click on the Advanced button.

Click on the Install CMC Drivers button.

• If you get a security warning, click Run Anyway.

Select Install ECU.

• If you get a security warning, click Run Anyway.

Click Next on the Drivers Welcome Screen.

On the Congratulations Screen, click Finish. 

• It displays the first part of the Driver is installed.

It will then start the second installation. 

On the Drivers Welcome Screen, click Next.

On the Congratulations Screen, click Finish. 

• It displays that the second part of the Driver is installed.

If desired, click the Release button on the completion screen to read the Release Notes.

Click Quit to close the installation screen. 

• The Drivers are now installed.

Plug in the USB Cable to the ECU.

Turn on the ECU.

Start up the FrameShop software by double-clicking on the FrameShop Shortcut on the desktop.